LabVIEW (Laboratory Virtual Instrument Engineering Workbench) is a programming as well as simulation software developed by National Instrument company. With this software you can make very complicated programme without any programming knowledge. Also you can connect your computer with physical instrument and control with this software. This software has limitless capability and there are several instruments are out there to connect with labVIEW. The most popular is NI Card (DAQ- Data Acquisition). NI card are also developed by national instrument and it is very costly. There are also several low cost solutions available but there efficiency and data aquisition rates are lower than the NI card. But for simple application (i.e Stepper motor control, Blinking LED, Servo motor control, Reading Voltage, Temperature reading etc.) we can use Arduino, Raspberry Pi. For little bit better we can use Labjack.
Arduino LabVIEW and DIY-Electronics Tutorials
Comments
Post a Comment